Start
T5
Torx
DriverLift this tabStraight up
PalmOne Tungsten E2 with T5 Torx
screwdriverRemove 4 Torx screws from
rear of unitPositive
Battery
LeadUsing case opening tool
Release plastic snap detail
holding rear cover to front caseBatteryDocking
ConnectorUnplug Battery cable from
motherboard. For future reference
positive lead is facing away from
the docking connector as shown
at left. (continued on page 2)Tools Required: Case opening tool, T5 Torx
ScrewdriverBattery connector
on MotherboardNote: Antistatic Procedures must be
followed when handling all electronics
Page 1 of 2Caution: battery cable is
connected to the battery
that is fastened to the rear
cover and to the battery
connector on the
motherboardPDA Smart
Cedar Park, Texas
Description:
PalmOne Tungsten E2
Disassembly Instructions
Date:
Created By:10/12/2007
T MattoxPlastic FasciaLift this tab
Straight upIf the battery is to be replaced,
carefully lift it from the double stick
tape using the case opening tool.
If only replacing the battery, stop here.Unplug the LCD Data cable by lifting
on the flex cable with your finger on
The left side. *Carefully lift the plastic fascia
From the front cover assemblyLift the motherboard from the
front cover assembly. *ENDDisassembly is complete. Re-assembly
Is the reverse of this process.
Tools Required: Case opening tool, T5 Torx
ScrewdriverLift the LCD assembly from the
front bezel. *
*Note: Antistatic Procedures must be
followed when handling all electronics
Page 2 of 2PDA Smart
Cedar Park, Texas
Description:
PalmOne Tungsten E2
Disassembly Instructions
Date:
Created By:10/12/2007
T Mattox